Some bunny loves you.

So Today I made a hidden pull tab card. Using Time for Tea Designs bunny Digi stamps.

 Print the Bunnies "don't worry be hoppy" and "no bunny compares to you", the "some bunny" sentiment and the "loves you" sentiment Digi stamps. Stamp some flowers and mushrooms using the "beauty sleep" and "butterflies" stamp sets and die-cut some clouds from the "box clever" die set or draw some clouds freehand.

To colour them in I used Spectrum Noir Tri-Blends "Red Brown blend" for the bunnies, "Pale pink blend" for inside the ears, "Magenta blend", "Burnt orange blend" and "citrus blend" for the flowers, "dark red blend" for the mushrooms and "ice grey blend" for the shading on the all the white bits.  

Fussy cut the bunnies, flowers and mushrooms. I cut the bucket away from the "no bunny compares to you" Digi stamp so he looks like he's looking out a hole. Cut the sentiments into rectangles, I did this using a scoreboard.

Cover an A6 card with Ombre green/blue card from Make and Create Ombre design pad (brought from The Works). 

Then die-cut a piece of smooth white card using the biggest frame in Time for Tea's "Hello nesting rectangle die set" and then die-cut the slider hole using the long thin rectangle from the "Box clever" die set (you could use the long thin rectangle in the hello set if you preferred but it's slightly shorter). 

Use Hunkydory Prism ink pad "blue lagoon" and the beautiful blender brushes to make the sky effect.

Cut a piece of scrap card to be just wider and about half an inch longer than the die used for the slider hole. 

Then add foam tape to the back of the card, making a track for the slider mechanism at the same time. Make sure you leave the left side (from the back) of the slider hole bare or you won't be able to put the slider mechanism in (which I forgot to do and had to the foam pad off ).

TIP: Wipe the edges of the foam tape with talcum powder or anti-static brush/pad to make sure the slider part slides smoothly.   

When that is stuck down put the slider mechanism into the hole.
Cut a small piece of scrap card, stick it to the back of your running bunny, make sure your bunny can be seen over the grass. Then using foam pads stick the bottom of the scrap card to the slider mechanism so the bunny should slide across your card.
To make the grass I die cut a piece of green/yellow ombre card using the same frame die as before and then freehand cut a grassy top.
Then using foam pads only along the sides and bottom (NOT the top or it will stop your bunny from sliding) stick the grass to the card.

Stick the "some bunny" to the lower right edge, then pull the slider mechanism out and stick the "loves you" sentiment onto the slider so it lines up with the other sentiment. 

Add the flowers, mushrooms, other bunny and the clouds and you're done.

The stamps, dies and blending brushes can be brought Here